useming43
motocykl
Dołączył: 26 Sty 2011
Posty: 301
Przeczytał: 0 tematów
Ostrzeżeń: 0/10 Skąd: England
|
Wysłany: Sob 3:59, 12 Lut 2011 Temat postu: channel puma How apt Replace a PSP Screen-_10033 |
|
|
11. Attach the brown cables to the same clasps, with the right cable in the right button and the left cable in the left clasp. Use your flathead screwdriver to elevator the clasps up as you put the cables in place.
8. Bring the PSP screen forward so it is arranging face down. Two brown wires reserve the screen chained to the circumferences of the PSP. These cables are chapter of the screen, so they will be replaced by the cables on the new screen.
10. Place the new PSP shade face down in the same situation namely the age one was in. Remove anyone plastic movie there might be then line it up with the top of the shade.
1. Make sure you have entire the appropriate tools before hand. Once you are ready, turn off the PSP.
13. Reattach the faceplate and area the battery behind into the PSP. Secure it with the 5 screws. Once interlocked everything should be competent to appropriate right back in the PSP and then it should escape fair as new,[link widoczny dla zalogowanych]!
4. Place your PSP face down on a clean, smooth surface,[link widoczny dla zalogowanych], face up. Pull the circuitous part of the stick away from the PSP, and it will slide off.
12. Fit the screen into place and push the 4 clips back in,[link widoczny dla zalogowanych], securing the new PSP screen. You can push the clips back into place with your finger until they fit snugly approximately the screen.
7. Use a flathead screwdriver to push out the clips holding the PSP's screen in place. There are 2 clips on the left side of the screen and two clips on the right. Tilt the screwdriver toward the centre of the PSP, which will cause the clips to push mundane and loosen the screen.
5. Turn your PSP over and situate the five screws above the back of the PSP. There namely one screw in every edge, with the screw in the bottom-left corner slightly obscured by the warranty sticker. Do no cut off the engagement sticker---instead,[link widoczny dla zalogowanych],[link widoczny dla zalogowanych], fold it back just enough so you tin way the screw. If the warranty sticker is damaged,[link widoczny dla zalogowanych],[link widoczny dla zalogowanych], it ambition void your PSP's warranty.
Requirement
2. Remove all accessories attached to your PSP, including game discs and memory sticks.
3. Remove the battery cover from the back of the PSP. Take out the battery and place it aside.
6. Lift the back of the PSP off the faceplate. Put the faceplate aside and place the PSP on its back.
Replacement PSP screenPhillips screwdriverFlathead screwdriver
How to Replace a PSP Screen?
The PSP is an perfected handheld game console with a slippery LCD screen. The PSP screen can transform damaged through repeated use,[link widoczny dla zalogowanych], and you'll need to replace the entire screen. Doing so requires you to buy a new PSP screen. You can replace the screen on your PSP by yourself whether you feel snug disassembling electronic devices.
9. Use your flathead screwdriver to push up the clasps connecting the cables to the motherboard. Gently slide the cables out and fully separate the PSP screen.
Post został pochwalony 0 razy
|
|